Open the back of your vivint panel, connect an Ethernet cord to the Ethernet jack and hook up your computer/laptop.There is a simpler method using WDS built into the doorbell. You can take it over in just a few steps: I’m assuming your Doorbell Cam is paired to your vivint panel already. (Both of my 2GIG and VIVINT panels had 2 separate ones.) Running those to a OH2 sensor you could setup a rule inside the panel for upstairs motion sensor for example: If triggered then trigger alarm1 only if triggered while the system is armed.Īnyway good luck hope this helps for some of the low-hanging fruit. The easiest integration would be to tie into the “alarm out” contacts in the back of the unit. That said, I’m sure I could out-stubborn most of the components eventually. My eventual takeover of the other devices eventually ended due to me needing a working security system, so I went with ADT as they were not pushy pricks. It has many very cool features like motion detection and auto recording to ftp or smb network share. There is no reason you cant have it up and running on the vivint system and also accessible to yourself. I was able to take over the doorbell camera quite easily, let me know if you need help with yours, (if you have one). Hi, good luck on taking over those sensors, I posted the article referenced above in the “OH2 Beginners” area.